Where skylight leaks start
A skylight is a hole in the roof, sealed in layers. Water gets in where one of those layers fails:
- Flashing. The metal skirt around the unit sheds water around it. On older installations it was often tarred instead of flashed, or it has rusted, lifted or cracked. This is the most common cause.
- Shingles around the unit. The courses on the uphill side and along the sides have to lap the flashing correctly. Missing or broken shingles there send water under the flashing.
- Seals and gaskets. The rubber that seals the glass to the frame dries and shrinks in the sun over the years.
- The curb. On curb-mounted skylights, the raised wooden frame the unit sits on can rot if water has been getting in for a while.
- The glass or dome. Less often, a cracked pane or dome lets water straight through.
Leak, or condensation?
Warm, damp air from inside condenses on cold glass in winter and drips down the frame, which looks exactly like a leak. Bathrooms and kitchens are the usual places. A real leak follows rain; condensation follows cold mornings. We check both, because one is roofing work and the other is ventilation, and sometimes a better-ventilated room or attic solves it. See attic ventilation if the attic is damp too.
Repair or replace
If the glass and frame are sound, new flashing and seals usually stop the leak for good. If the glass is fogged or cracked, the frame is rotted, or the unit is old enough that its parts are no longer made, skylight replacement is the better value. We tell you which, with photos.