Where roof leaks really start
Most roof leaks start at the joints, not in the middle of a shingled slope. The usual places to look:
- Flashing around chimneys, walls and skylights that has cracked, lifted or was sealed with caulk instead of being properly installed. More on this under chimney and flashing repair.
- Plumbing vent boots, the rubber collars around pipes, which crack in the sun after some years.
- Missing or torn shingles after wind, which expose the nails and underlayment beneath.
- Overflowing gutters that push water back under the edge of the roof in heavy rain.
- Skylights, at the flashing or the seal of the unit itself. See skylights.
Flat roofs leak in their own ways, at seams, drains and parapet walls; those are covered under flat roofing.
Why a patch on the stain does not work
A quick dab of roofing cement where the water seems to come in rarely holds. The real entry point may be elsewhere, and cement dries, cracks and lets water in again within a season. A lasting repair replaces the part that failed, whether that is a flashing piece, a boot, a few shingles or a section of rotted board, and puts the layers back the way they are meant to shed water.
While you wait
If you see water now, put a bucket under the drip, move furniture and electronics out of the way, and keep away from any light fixture with water near it. Do not go on the roof in rain or wind. Then call (347) 323-9128. The emergency roof repair page lists what to do in the first ten minutes.