Why flashing fails
A roof is easy to keep dry in the middle of a slope, where shingles overlap like scales. The hard part is every place the roof meets something else: a chimney, a dormer wall, a vent pipe, a skylight. Those joints are sealed with flashing, thin metal pieces shaped and layered so water runs over them and away.
Flashing fails in a few predictable ways. The metal corrodes or cracks with age. The house and the chimney move at different rates through summer heat and winter freezes, and the joint pulls open. Mortar holding the top edge into the chimney crumbles. And many joints were never flashed properly in the first place: a bead of caulk or a layer of tar was used instead, which works until it dries out.
How proper flashing is built
Around a chimney there are two layers. Step flashing, small bent pieces, is woven in with each course of shingles up the sides of the chimney, so every piece overlaps the one below it. Counter-flashing is set into a cut in the mortar and folds down over the step flashing, so water running down the brick cannot get behind it. Wider chimneys also need a small peaked section on the uphill side, called a cricket, so water and debris flow around the chimney instead of piling up against it.
Walls and dormers use the same step-flashing principle. Vent pipes use a boot or collar that slides over the pipe and sits under the shingles above it.
What we tell you
After the inspection you get photos of each joint and a plain explanation: what is failing, what is fine and what it costs. If the problem is the chimney itself, such as cracked mortar or a missing cap, we say so. Leaks around skylights are covered under skylights; other causes are on roof leak repair.