How passive ventilation works
Warm air rises. A passive system uses that: cooler outside air enters through vents at the lowest part of the roof, the soffits under the eaves, warms in the attic and leaves through vents at the highest point. No power, no moving parts. It only works if both ends are open and balanced.
The vents
- Soffit vents: perforated panels or strip vents under the eaves. The intake. They are often painted over or blocked from inside by insulation, which baffles fix.
- Ridge vent: a continuous vent along the peak, hidden under the ridge cap. The most even exhaust for most pitched roofs.
- Roof vents: box vents or turbines near the top of the roof, used where a ridge vent will not fit.
- Gable vents: louvered vents in the end walls of the attic, common on older houses.
Balance
The usual guideline is about equal intake and exhaust, with slightly more intake. Too much exhaust and not enough intake pulls conditioned air from the house below. Two kinds of exhaust together, such as a ridge vent with gable vents or a fan, can short-circuit each other. We look at the whole attic and fix it as one system.
With a new roof
The easiest time to add a ridge vent is during a roof replacement: the ridge is open, the vent is cut in along the peak and capped with the new ridge shingles. If you need powered ventilation instead, see attic fans.